This zip folder contains two toolpath (.tap) files and the Vcarve (.crv) project they were created from.

Toolpath .tap files:
The "*machine name*-spoilboard.tap" file utilizes a 1 inch surfacing bit and is zeroed to the BOTTOM LEFT corner and to the MATERIAL SURFACE. This file will cut a border around the Shark CNC machine's engraving area, then surface in the engraving area.

The "*machine name* - 1 inch Grid.tap" file uses a 90.0° - 1/2" V-bit to create a 1 inch grid pattern in the engraving area of the Shark CNC machine. This file is also zeroed to the BOTTOM LEFT corner and to the MATERIAL SURFACE.

Vcarve .crv project:
The "*machine name*.crv" requires Vcarve 11 with update to open. If you are making changes to this project, make sure that you recalculate the toolpaths for any changes and then save new toolpath .tap files to run on the machine.